chugger-pump-cpss-ci-side-web
Chugger Pump CPSS-CI

CPSS-CI-2 (230v)

The CHUGGER PUMP® CPSS-CI-2 Stainless Steel Center Pump 230V is a homebrew beer pump which is typically used to transfer hot and/or cold liquids between brewing vessels.

Datasheet & Dimensional Drawings

SKU: CPSS-CI-2 Category: Tags: , , ,

Product Description

CPSS-CI-2

CPSS-CI-2

CPSS-CI-2 316 STAINLESS STEEL (Front Housing), 316 Stainless Steel (Rear Housing), Teflon (Thrust Washer), CLEAR Silicone (O-Ring), Ryton/Teflon Impeller

Inlet 3/4″ MPT & Outlet 1/2″ MPT

  • Max Flow: 7 GPM 26.5 LPM
  • Max Head: 18.6 FT 4.1 M
  • Power: 1/20 HP (.04 HP) .029 KW
  • Electrical: 115V 50/60HZ
  • Non-Submersible
  • Motor AMP Rating – Full Load Amps (FLA)
  • Motor Only: 1.7 Amps
  • Motor and Pump: 1.9 Amps
  • Can handle liquids of 250° F
  • Materials are FDA Food Compliant
  • Components are UL Recognized

The ETL Listed Mark indicates to distributors, retailers and customers that your product has been tested by Intertek and found in compliance with accepted national standards. Click Here for more information.

Additional Information

Weight 7 lbs
Model

CPSS-CI-2

Connections

Inlet 3/4″ MPT & Outlet 1/2″ MPT

Max Flow

7 GPM

Max Head

18.6 Feet

Horsepower

1/20 HP

Voltage

230 Volt

Hertz

50 / 60 Hz

Max Liquid Temperature

250° F

Weight

7 Lbs

Product Warranty

CHUGGER PUMP® CPSS-CI-2 (203v) is warranted only against defects in workmanship for a period of 6 months from the date of purchase. DO NOT RUN THE PUMP DRY, it will not be covered under warranty.

Tips & Troubleshooting

  • A squealing sound is a waring that you are running the pump with no fluid.
    • Power Off Immediately!
  • Do not plumb the inlet tubing of connections with less than 1/2" Full Port Fittings.
    • This will result in cavitation and problems with your pump!

Product Installation

The CHUGGER PUMP® CPSS-CI-2 (230v) is shipped ready for installation. Directional arrows on the pump head show fluid direction through the pump. The four screws on the pump head may be removed and the pump head can be rotated as required to fit your piping system.

For Your Information

  • Check Out This Video - How to Change a Chugger Pump Orientation
  • The motor should be oiled yearly with 4-5 drops SAE20 weight non-detergent oil, do not over oil.
  • Follow all local electrical safety codes and always disconnect power before performing work on or near the pump motor.